Need Arm WATERPROOF CAST COVERS 

Size Chart Waterproof Leg Cast Cover

NOTE: Cast cover opening will be tight when going over the cast.  It needs to be tight so it can fit snug around the arm or leg.  Fitting snug will allow it to create a vacuum waterproof seal.

NOTE:  The above size ranges are the min and max to fit the xerosox.  If you are close in the region of +/- 1/4 inch it may fit you.  XeroSox is intended to fit the general population and may not fit everyone.  If you are outside the above size range this item may not fit you.

 How To Get Measurements for the XeroSox Waterproof Cast Cover

1) Measure Limb Circumference

Do not measure around the cast, but around the bare leg as in the photo.

Leg: Measure the circumference of the leg just above the cast or bandage. If the end of the cast is very close to the knee, measure mid thigh.  The circumference is also where you measure the length to the heel. 

2) Measure Length

Leg: Measure from the back of the heel to where the circumference was measured (which is about 1-2 inches above the cast line, See circumference line above).  For younger children the full arm and full leg XeroSox^® offer the best fit; measure from their mid bicep or mid thigh. Don't worry if the XeroSox^® is longer than it needs to be. Move the extra length to the middle of the limb, the excess material will just shrink in on itself when the vacuum is created.

3) Use Size Charts

Using the size charts select the XeroSox^® size that is right for you or your patient.

The circumference is more important than the length because it is critical for a good seal.

*Note the half arms and half legs are not normally used for children. Pediatric patients almost always use full arm or leg XeroSox^®.